Cast Iron Wood Stove for Fireplace installation - Hearth.com

Hi all, in my previous thread I was looking for advice on a fireplace insert. Thanks to some suggestions made there, I've been swayed in the direction of a wood stove instead. It won't cover up the fireplace facing, and as a bonus could be a secondary cooking appliance. The aesthetic is important though, so for that reason I'm looking at cast iron stoves. I'm also primarily looking at those that qualify for the tax credit, but I'm open to those that don't as well. Since it will be piped up the existing fireplace chimney and the fireplace opening is 31.5x31.5, I believe the flue will have to be rear exit.

The stoves I'm looking at primarily are:

• VC Encore
• Hearthstone Shelburne
• Jotul F500
• BK Ashford 30.2 (may be slightly too tall)
• PE Anderlea T5 or T6 (possible too tight a fit - no tax credit)

Reading around on the site here, it seems that the VC is a complicated stove and prone to expensive maintenance. The Hearthstone is lined in soapstone that seems to suck up heat that could otherwise be transferring into the space. The BK may be too tall to fit. The PE seems to be well liked in these parts, but is top flue only as far as I can tell, and would have to be recessed into the fireplace opening for that to work, which would leave only about 2 inches of clearance around the top and sides - probably too tight a fit even to get it installed.

What do you think of the stoves listed? Are there any that I'm missing that I should check out? Again, aesthetics are important which is why I'm not looking at steel stoves. Thanks for any feedback or advice. I’d look at the Woodstock line too. Cooking on them is overrated and if you get an enamel stove you probably just won’t as you don’t want to damage the enamel with pans. I’m hesitant to stick a BK stove back in the opening with the thermostat. My feeling is that it is calibrated for heat loss in a normal install.

If I had a good dealer I’d be tempted to go with the F500 knowing it’s had issues. How how would a T5 insert look? Is it’s surround bigger than the opening? I could see installing a surround inside the opening for an insert if the opening is bigger than the surround. That would make the BK ashford insert an option too.

I spent a lot of time searching for mine only to find I didn’t have that many options. Add emissions and wanting the tax credit the list gets really short.

Evan

I’d look at the Woodstock line too. Cooking on them is overrated and if you get an enamel stove you probably just won’t as you don’t want to damage the enamel with pans. I’m hesitant to stick a BK stove back in the opening with the thermostat. My feeling is that it is calibrated for heat loss in a normal install.

If I had a good dealer I’d be tempted to go with the F500 knowing it’s had issues. How how would a T5 insert look? Is it’s surround bigger than the opening? I could see installing a surround inside the opening for an insert if the opening is bigger than the surround. That would make the BK ashford insert an option too.

I spent a lot of time searching for mine only to find I didn’t have that many options. Add emissions and wanting the tax credit the list gets really short.

Evan

I looked at the Woodstock stoves, but they look fit for a Victorian mansion which isn't what I have here. The ability to cook on them would just be for times of power outages and such - not something we'd do often but seems like a nice value add.

The T5 insert would fit pretty well width wise, but would leave a gap at the top that I'd have to fill in somehow.

Why would you go with the F500 over the others, if you had a good dealer?

I looked at the Woodstock stoves, but they look fit for a Victorian mansion which isn't what I have here. The ability to cook on them would just be for times of power outages and such - not something we'd do often but seems like a nice value add.

The T5 insert would fit pretty well width wise, but would leave a gap at the top that I'd have to fill in somehow.

Why would you go with the F500 over the others, if you had a good dealer?

The VC stoves just do not impress me. there are just better designed stoves out their from a functional point of view. Hearthstones Just seem to be more temperamental. (probably it’s just more particular about it draft.). no experience with either one. And you could be very happy with either.

T5 and T6 are good and I go with those in a heart beat but if you have less than an inch clearance that just too tight to get good air circulation off the top IMO.

I have a Jotul and love it. Rock solid. I’m just not ready to say that about the new F500. So if you have a good dealer that will have your back and work through any potential issues thats my choice for the tax credit. But depending on how far back in the fireplace it is set you won’t be able to read the cat temp. Easily solved by a digital cat probe. but Again 1.5” or so clearance on each side is pretty tight. I’m assuming the side ash lip is removable. Has the option to top vent if you want it really tucked in or rear vent to a T if you want it out in front.

as far as the couple inches for the T5 insert. I would be more concerned with covering up 5” of the tile on each side. 31.5”w is pretty narrow and most/ all surrounds will cover up the tile unless you get a trim able surround.

I think you are making the right call with a stove Just makes finding the right one more difficult. Keep you eyes out for used F400 at 26”w it would fit will. Firebox is smallish though. Ah the trade offs.

I have a Jotul F500 installed in my fireplace. It works great but is is the older version. Dimensionally this should work Depending on the size of your hearth. No matter which you choose get their manual online first and check all the clearances. It was close with my Jotul. My particular set up makes it tough to clean the chimney but I hire it out. That is something else worth thinking about when you make your decisions.

Would you mind sharing a picture? My fireplace is all masonry/tile so the only clearance I need to worry about is the hearth. I had a chimney sweep out last week who cleaned and inspected everything. He does stove/insert installs as well, and said I'd just need a heath pad/rug for spark/ember protection in front but otherwise was good to go. If I go with the F500 it would be a little tight for sweeping, but if I get the short leg kit that would allow a little more room.

Would you mind sharing a picture? My fireplace is all masonry/tile so the only clearance I need to worry about is the hearth. I had a chimney sweep out last week who cleaned and inspected everything. He does stove/insert installs as well, and said I'd just need a heath pad/rug for spark/ember protection in front but otherwise was good to go. If I go with the F500 it would be a little tight for sweeping, but if I get the short leg kit that would allow a little more room.

So you will rear vent it? Pretty easy to clean the liner with a clean out T. Did you rule out a PE T5 or T6 tucked way back in? Personally not ever having to deal with a catalytic converter and the ease of sweeping bottom up I’d choose the PE.

So you will rear vent it? Pretty easy to clean the liner with a clean out T. Did you rule out a PE T5 or T6 tucked way back in? Personally not ever having to deal with a catalytic converter and the ease of sweeping bottom up I’d choose the PE.

Yes, planning to rear vent the Jotul. I think the T5/T6 might be too tight a fit. Since they are top vent only, they would have to be set in there pretty deep. The T6 would only have about 1.5" if clearance top and sides. The T5 would have a little more on the sides. Probably too tight to even install, and I'd not be able to cook on it in case of need. So unfortunately the PEs are out.

Companies specializing in fireplace accessories for period-style and older homes, including dampers, covers, fireplace tool sets, hearth rugs, wood racks, fireplace screens, grates, and more. 

For more information, please visit Lianjiang.

If you are looking for more details, kindly visit cusom cast iron fireplace supplier.

SEE ALSO: Mantels | Tile | Fireplaces | Chimney Fans | Chimney Pots | Chimney Restoration

For more aluminium gatesinformation, please contact us. We will provide professional answers.